Application Instructions

Preparation.

Before affixing the Magnet to a metal surface, be sure all surface paints, clear coats and waxes are cured or hardened.

Approximate curing times are:

• Paint: 90 days

• Clear Coat: 60 days

• Wax: 2 days

Prior to application, clean the metallic surface and the Magnet with a mild detergent. Wipe with a soft cloth and allow to dry. Follow the recommendations on the detergent and those of the car manufacturer.

The Magnet should be at room temperature when applying. Take care when handling the Magnet in cold conditions, as it can become brittle.

Location.

• Ensure surface is metallic and smooth, flat or only slightly curved.

• Don’t apply the Magnet on an area that isn’t steel or metal, or that has extensive non-metallic fillers.

  • Aluminum, wood, or fiberglass will not function as a surface.

Application.

• Affix the Magnet onto the surface.

• Make sure the entire Magnet is flat against the metal surface. Do not place over protrusions (molding, decals, pin striping, etc.) or concave areas.

• Ensure there are no air pockets or moisture between the Magnet and the vehicle surface, and that corners and edges are smooth and flush with the surface.

• Curvature on the edges of the Magnet may result in the Magnet falling off.

Final Touches.

To adjust the location of the Magnet after placement, remove completely and reposition by lifting from the sides to remove; do not remove from the corners. Please note that sliding the Magnet into position may cause stretching and/or scratching.

Warnings

Failure to review and abide by these warnings could result in damage to the Magnet or your vehicle, and could increase the likelihood that the Magnet will not adhere properly and may fall off during use.

• Lay Magnet flat for at least 24 hours.

• Never use a Magnet if it contains any bubbles, wrinkles, bent corners and/or edges or is otherwise damaged.

• Never exceed the speed limit or any recommended maximum speed.

• Don’t place the Magnet over protrusions, fixtures or concave areas, such as: molding, lights, reflectors, decals, pin stripes, air intakes, wells, and spoilers.

• Never apply the Magnet to horizontal metal surfaces (such as car roofs) and take care not to place it in direct or constant sunlight or extreme heat.

• Don’t layer one Magnet on top of another when applied to vehicles.

• Long-term outdoor usage of magnets on painted surfaces may result in fading, due to shielding the underlying color from ultraviolet rays.

• The Magnet is not for use underwater or on aircraft.

• Make sure to remove the Magnet from any vehicle before a car wash.

*FAILURE TO ADHERE TO THE AFOREMENTIONED INSTRUCTIONS MAY LEAD TO POTENTIAL HARM TO BOTH THE MAGNET ITSELF AND THE SURFACE TO WHICH IT IS ATTACHED. ADDITIONALLY, IT CAN HEIGHTEN THE RISK OF INADEQUATE ADHESION, POTENTIALLY CAUSING THE MAGNET TO DETACH DURING USE. ALEF BY CORDOBA, AS WELL AS ITS OFFICERS, DIRECTORS, EMPLOYEES, OR OTHER ASSOCIATES, WILL NOT ASSUME ANY RESPONSIBILITY FOR CLAIMS, LOSSES, OR DAMAGES INCURRED BY THE MAGNET, THE AFFIXED SURFACE, OR ANY OTHER PROPERTY OR INDIVIDUAL. THIS INCLUDES, BUT IS NOT LIMITED TO, DAMAGES RESULTING FROM PERSONAL INJURY CAUSED BY IMPROPER USE, ABUSE, OR FAILURE TO COMPLY WITH THE PROVIDED INSTRUCTIONS.